Instruction manual

62
z Load cut-sheet smoothly again.
Paper-feed slanting or paper-jam:
z Turn off the printer power switch, and set the path selection lever to
the position of pull tractor, remove cut-sheet and check the following
two contents.
z Make sure that the size of cut-sheet is within the specified range.
z Make sure that the cut-sheet aligns with both edge guides.
Cut-Sheet is not ejected completely:
z Please use LOAD/EJECT button to eject cut sheet. Do not use LF/ FF
button.
z It may be caused by too long cut-sheet, please use the standard-size
cut-sheet.
The continuous paper cannot be loaded correctly:
The platen is running, but the paper cannot be loaded:
z Check if path selection lever is on the correct position.
Paper-feed is slanting or paper jam:
z Confirm whether the continuous paper is blocked by a cable or other
objects. You should make sure that the continuous paper can be fed
smoothly.
z Confirm if the distance between the continuous paper and printer is
within one meter.
z The position of putting continuous paper may interfere with the
vertical feeding of continuous paper.
z Check if both holes of continuous paper are parallel with each other,
and whether the sprocket of tractor is locked and the cover is closed.
z Check if the position of the gap lever accords with the type of paper
used, please refer to gap lever section.