User manual

Configuring the Printer
A78408098-005
50
3. Press the → key to select the macro for which you want to set the paper
size (
MACRO#1,MACRO#2,MACRO#3
or
MACRO#4
).
4. Once the desired macro is displayed press the ↓ key until the following
parameter is displayed:
LENGTH xx
5. Press the → or ← key until the desired page size is displayed.
6. Press again the
PROGRAM
key to exit the menu end set the new value.
Adjusting the Tear-Off Position
The default value for the Tear-Off Function is
TEAR NORMAL
. To check the
Tear-Off Position proceed as follows:
1. To move the paper to the Tear-Off position, press the
ON LINE
key when
the printer is disabled or enabled without printing.
2. Check if the paper perforation matches the tear-off bar on the printer.
If it does not:
1. Press the
PROGRAM
key to enter the Program Setup.
2. Press the ↓ key until the following message appears:
USER MACRO
3. Press the → key until the macro for which you want to adjust the tear-off
is displayed (#
1, #2, #3
or #
4
):
MACRO # x
4. Press the ↓ key until the following message is displayed:
TEAR ADJUST xxx
5. Press the → or ← key to scroll the values of this function.

The values below 0 move the tear-off position downwards, values above 0 move
the paper upwards. The values can be set between -30 and 360 at 1/180 inches
(-1/6 to 2 inches).
6. When the desired value is displayed, press the
PROGRAM
key. The
storage options are displayed.
7. Press the → or ← key, until the following message is displayed:
STORE? SAVE
8. Press the
PROGRAM
key to exit from the menu.