User manual

2.
The adjustable range is 1/6" to +1" from the factory default position. If
the adjusted position is out of this range, the setting will be ignored (the
buzzer sounds.)
3.
Press the
ON LINE/←
key to save the new Auto Loading position.
4.
To cancel the Auto Loading Position Adjustment Mode, press the
FORM
FEED
/
↓
key.
Switching From Fanfold Paper to Single Sheet
(Paper Park Function)
If you have been using fanfold paper in the Push tractor position and you want
to load single sheets do not remove the fanfold paper but park it.
Make sure that the printer is in Off line status. You can perform the paper
switching as follows:
1.
Tear the printed fanfold paper along the last perforation.
2.
Press the
LOAD-PARK/→
key. The fanfold paperwill be parked.
3.
Set the friction release lever to the Friction position.
4.
Insert a single sheet into the printer.
5.
Press the
FORM FEED
/
↓
or the
LOAD-PARK/ →
key. The single
sheet is loaded automatically.
6.
After printing on the single sheet, set the friction release lever to
the Tractor position to resume printing on the fanfold paper.
Chapter 3
A78401745-001
3.35