User manual

Setting Margins
ESC l {n}
Sets left margin (only EPSON mode).
1B 6C {n}
27 108 {n}
0 ≤ n ≤ 229
This code sets the left margin at the current horizontal spacing. It must be sent at
the beginning of the line. {n} is the number of columns. The left margin must be
smaller than the right margin.
ESC Q {n}
Sets the right margin (only EPSON mode).
1B 51 {n)
27 81 {n}
1≤ n ≤ 255
This code specifies the line length required at the current horizontal spacing. It
must be sent at the beginning of the line. {n} is the number of columns and for
each type of horizontal spacing there is a range of values. The right margin must
be greater than the left margin.
ESC X {n} {m}
Sets left and right margins (only IBM mode).
1B 58 {n} {m}
27 88 {n} {m}
0 ≤ n ≤ 255
0 ≤ m ≤ 255
This command sets the left and right margins simultaneously. The {n} and {m}
parameters indicate respectively the number of columns for the left and right
margin at the current horizontal spacing. These margins are memorized in terms
of absolute displacement from the physical left edge of the page. If {n} is equal
to 0, the current left margin value is used. If {m} is equal to 0, the current right
margin is used.
ESC 4
Sets top of form (only IBM mode).
1B 34
27 52
This sequence sets the current paper position as top of form that is first printable
line.
Appendix A
A78401745-001
A.7