User Manual
Table Of Contents
- Selecting the Display Language
- Configuring the Printer
- Operator Panel Presentation
- Printer Setups
- Power-On Configuration
- Entering the Power-On Configuration
- Printout of the Printer Settings
- Emulation Options
- Parallel Interface
- Serial Interface
- LAN Interface
- LAN Interface Parameters
- IP Assignment
- Enable/Disable the Novell Service
- Enable/Disable the SMTP Service
- Init IP Address
- Init Net Mask
- ID Default Gateway
- Mail Server Address
- Init Host Name
- Init Workgroup Name
- Security User Name
- Security Password
- E-mail Address
- Print Server Name in Novell Network
- Printer Name in Novell Network
- Queue Name in Novell Network
- Frame Type in Novell Network
- LAN Interface Parameters
- Functions
- Functions Group Parameters
- Setting the Functions Group Items
- Paper Loading Sequence
- Enable/Disable the Buzzer
- Ribbon Type Selection
- Bar Code Density
- Text Print Direction
- Graphics Print Direction
- Bar Codes Print Direction
- Paper Path at Power-On
- Selection of the Language of the Display Messages
- Enable/Disable Lower Tractor Jam Sensor
- Enable/Disable Upper Tractor Jam Sensor
- Adjusting the Tear-Off Position
- Resetting to Factory Default Values
- Entering the Power-On Configuration
- Program Setup
- Entering the Program Setup
- Main Structure
- Printout of the Printer Settings
- User Macro
- Selection of the User Macro
- User Macro Parameters
- Line Spacing
- Line Spacing Lock
- Page Length
- Top of Form
- Skip Over Perforation
- Draft Print Mode Selection
- Font Selection
- Pitch Selection
- Micro Dot Print Mode
- Pitch Lock
- Left Margin
- Right Margin
- Zero Character Printing
- Paper Path Selection
- Tear-Off Mode
- Print Impact Strength
- Paper Perforation
- Quiet Printing
- Adjusting the Distance of the Print Head
- Horizontal Character Tuning
- Vertical Character Tuning
- Resetting the Macro Parameters to the Factory Defaults
- Selecting Another Macro
- Passing over to the Power-On Configuration
- Hexadecimal Dump
- Entering the Program Setup
- How to Select the Paper Path
- How to Use the Tear-Off Function
- How to Lock/Unlock the Printer Setups
- How to Handle the Paper Parking
53
Number of Data Bits
SELECT-IN HOST
↑
DATA BITS 8
→ or ←
DATA BITS 7
→ or ←
↓
INPUT BUFFER 2K
Selection of the number of data bits: 7 or 8
Input Buffer Size
DATA BITS 8
↑
INPUT BUFFER 256
→ or ←
INPUT BUFFER 2K
→ or ←
INPUT BUFFER 12K
→ or ←
INPUT BUFFER 32K
→ or ←
INPUT BUFFER 64K
→ or ←
↓
PARALL. INTERFACE
Selects the input buffer size. If the input buffer is set to 64K, the DLL is not available.