User Manual
Table Of Contents
- Selecting the Display Language
- Configuring the Printer
- Operator Panel Presentation
- Printer Setups
- Power-On Configuration
- Entering the Power-On Configuration
- Printout of the Printer Settings
- Emulation Options
- Parallel Interface
- Serial Interface
- LAN Interface
- LAN Interface Parameters
- IP Assignment
- Enable/Disable the Novell Service
- Enable/Disable the SMTP Service
- Init IP Address
- Init Net Mask
- ID Default Gateway
- Mail Server Address
- Init Host Name
- Init Workgroup Name
- Security User Name
- Security Password
- E-mail Address
- Print Server Name in Novell Network
- Printer Name in Novell Network
- Queue Name in Novell Network
- Frame Type in Novell Network
- LAN Interface Parameters
- Functions
- Functions Group Parameters
- Setting the Functions Group Items
- Paper Loading Sequence
- Enable/Disable the Buzzer
- Ribbon Type Selection
- Bar Code Density
- Text Print Direction
- Graphics Print Direction
- Bar Codes Print Direction
- Paper Path at Power-On
- Selection of the Language of the Display Messages
- Enable/Disable Lower Tractor Jam Sensor
- Enable/Disable Upper Tractor Jam Sensor
- Adjusting the Tear-Off Position
- Resetting to Factory Default Values
- Entering the Power-On Configuration
- Program Setup
- Entering the Program Setup
- Main Structure
- Printout of the Printer Settings
- User Macro
- Selection of the User Macro
- User Macro Parameters
- Line Spacing
- Line Spacing Lock
- Page Length
- Top of Form
- Skip Over Perforation
- Draft Print Mode Selection
- Font Selection
- Pitch Selection
- Micro Dot Print Mode
- Pitch Lock
- Left Margin
- Right Margin
- Zero Character Printing
- Paper Path Selection
- Tear-Off Mode
- Print Impact Strength
- Paper Perforation
- Quiet Printing
- Adjusting the Distance of the Print Head
- Horizontal Character Tuning
- Vertical Character Tuning
- Resetting the Macro Parameters to the Factory Defaults
- Selecting Another Macro
- Passing over to the Power-On Configuration
- Hexadecimal Dump
- Entering the Program Setup
- How to Select the Paper Path
- How to Use the Tear-Off Function
- How to Lock/Unlock the Printer Setups
- How to Handle the Paper Parking
98
Passing over to the Power-On Configuration
At this point of the setup, it is possible to pass over to the Power On Configuration functions setting.
NEXT MACRO NO
↑
CONFIG MENU NO
→ or ←
CONFIG MENU YES
↓
↓
HEX DUMP NO PARALL INTERFACE
These items are self-explaining.
Hexadecimal Dump
CONFIG MENU NO
↑
HEX DUMP NO
→ or ←
HEX DUMP YES
↓
STORE? QUIT
If you select HEX DUMP YES, press the
PROGRAM
key to set this item. The hexadecimal printing
continues, until the HEX DUMP NO item is selected, entering again into the Program Setup.