Installation manual

33
STEP 3: Once finished scrolling through the menu wait for the parking lights and/or siren chirp to confirm
the option number. i.e. option 2-04 will flash 4 times. Then use one of the table selections to select the
option corresponding to your desired setting.
Resetting to Factory Defaults: To reset the options in a particular menu group, enter the menu shown
in the above tables. To reset options with a 2 Way remote tap button 3 three times. To reset options with
a 1 Way remote tap the Key/Start button 3 times. Wait for the siren to chip and parking lights to flash
between each tap. After the third tap, the option menu will reset and the siren will chirp three times. This
must be done for each option group that needs to be reset.
Troubleshooting
Remote Start Error Codes
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following
those three flashes the parking lights will flash again corresponding to the error table below:
Number of
Parking Light
Flashes
Remote Start Error
1
Motor running or must program tach before 1
st
remote start
2 Key in ignition on position
3 Door open (manual transmission only)
4 Trunk open
5 Foot brake on
6 Hood open
7 Reservation off (manual transmission only)
8 Tach or no tach sensing failure
*Pro 2 Way remotes will display the error number “Strt Er##” on the LCD.
Alarm LED Diagnostics
Alarm and Alarm / Starter Control Modules Only
When the alarm is triggered the LED on the RPS (if installed), Secure Valet (if installed) and the LED (if
installed) will flash a certain amount of times as shown in the table below. This is intended for users with
1 Way remotes.
Frequently Asked Questions
I have everything hooked up and the system will not respond.
A: The remotes need to be programmed. Review the “Common Procedure” section of this manual.
Priority Trigger LED Flash Diagnostic
1
Door/Hood/Trunk/Ign
Triggered
2 flashes, rest, then repeat
2 2
nd
Shock Triggered 3 flashes, rest, then repeat
3
2
nd
Auxiliary Input
Triggered
4 flashes, rest, then repeat
4 Panic with remote 5 flashes, rest, then repeat