Manual Chapter 4

4-32 Setting Up and Using Laser Alignment Fixtures
Install the 8000RF Interface onto the RS232 serial port of the UltraSpec
analyzer by completing the following steps:
1. ··· Ensure that the UltraSpec analyzer is turned off.
2. ··· Connect the 8000RF Interface to the RS232 25-pin connector to the
UltraSpec analyzer.
3. ··· Turn the UltraSpec analyzer on.
Note
The RF antenna on the 8000RF Interface does not rotate or
twist. Therefore, trying to rotate or twist the antenna will only
result in damaging the 8000RF Interface.