Manual Chapter 4

4-17

Precautions

Please follow these precautions carefully. Any product damage due to these

conditions may void the warranty.

•

Do not

change the battery pack with the battery charger connected as

damage may occur to the analyzer.

• Use only CSI-supplied battery chargers that have been approved for

use with UltraSpec analyzers and Model 8215/8225 laser heads. The

use of any other charger will most likely damage the equipment.

• Do not use CSI battery chargers with anything other than what they

are designed for! Do not use the 8211 or 8212 to charge anything else!

• Do not repeatedly overcharge the analyzer batteries. If the batteries

are continually allowed to remain in the “Fast” charge cycle for

periods longer than the recommended 14 to 16 hours, battery degra-

dation will occur.

• Do not use any batteries other than those included and/or speciﬁed

for UltraSpec analyzers and 8215/8225 laser heads.

• Do not connect a signal larger than ± 21 volts into the input of the

analyzer.

• Do not connect any signal other than a TTL-level signal to the

tachometer input. Other signals may damage the analyzer.

• Do not connect a printer directly to the RS232 port located on the

top panel of the analyzer.

• Do not connect any adapters or accessories to the RS232 port

located on the top panel of the analyzer while the analyzer is turned

on.

• Do not start the machines being aligned with the laser alignment

system equipment attached. Be sure to remove the laser system

before starting the machinery.