Manual Chapter 1

2-23
UltraSpec Analyzer Utility Functions
The Retries option specifies the number of times the analyzer will repeat
attempts to establish valid communication. If communication is not estab-
lished, the analyzer will display a communications error message following
the last retry and timeout cycle.
Note
CSI recommends a value of “one” for the Stop Bits setting. A
suggested timeout value of 10 seconds, and five retries should
allow sufficient time for the computer to process any commu-
nication errors and multiple jobs being loaded from UltraMgr.
The CTS Enable option should be set to “Yes” when using a modem that
supports hardware handshake via CTS signal (this includes most 9600 baud
modems).
Set Modem Commands
This menu selection is used to define the modem command string which
instructs the modem to dial a telephone number.
8
The example Set Modem screen above shows a modem command line for
use with a Hayes-compatible modem which will:
• Use tone dialing ATDT (ATDP for pulse dialing)
• Dial 1 and the area code 423
• Then dial the number 675-2400
Underneath “Type in New Commands,” use the alphanumeric keypad to
type in the desired letters/numbers. Press the Enter key to accept the new
modem number.