Manual Chapter 1

3-4 Options and Hardkey Functions

Recall Job

Recall Job is used to select a job in the stored job area. Select Recall Job

from the Alignment Options menu to access the screen shown below. Using

the Up and Down Arrow keys highlight any desired job

stored in the

UltraSpec memory

and then press the Enter key.

When recalling a job into the current job area where a job is already

located, you will receive a prompt asking if you want to overwrite the cur-

rent job. Pressing Enter allows the current job to be overwritten. If the job

is recalled successfully, a screen appears stating that it was a success. Press

Enter to continue. If you want to save the current job, press the Reset/Main

key to abort, then store the job using the process described under “Store

Job” on page 3-3.

Note

Follow these steps carefully to ensure that you do not overwrite

data that you really want to keep

Note

If there are more jobs than can be displayed on the analyzer

screen, use the Page Down key to page to the remaining selec-

tions on the list.

After selecting the job, the analyzer returns to the program’s Main menu.