Manual Chapter 5

5-18 Using UltraSpec Alignment - General Overview
Machine Dimensions (A through F)
Note
This section assumes that the fixtures are set up to the point
that the sensor heads are mounted.
After accepting the configuration, the following screen will appear.
Machine Dimensions (A) Screen
Measure all of the dimensions to the nearest 1/8 inch (3 mm) with the
exception of dimension C. Dimension C should be measured to the nearest
1/16 inch (1.5 mm). Refer to “Entering Fractions (Alignment Applications
Only)” on page 2-17 for instructions on entering fractions into the system.
Use the Up/Down arrow keys to select the field you want to modify; press
Enter to accept the entry. Refer to the following table for a description of
each dimension.
Note
The dimensions are the same for both the Model 8215 and
8225 laser heads.