Manual Chapter 5

5-19
Job Definition
Note
With large equipment, you may need to drop a plumb bob
from the sensor head to measure these dimensions accurately.
Dimension Measurement Description
Measure to
Nearest
A Center of outboard foot to center of inboard foot of the machine on
the left .
1/8 inch
(3 mm)
B
Center of inboard foot on the left machine to the sensor head face
on the left machine. To enter a measurement for a foot that falls
inside the laser face, place a negative sign (–) in front of it.
1/8 inch
(3 mm)
C
Measure from the inside face of one sensor head to the inside
face of the other sensor head.
1/16 inch
(1.5 mm)
D
Center of inboard foot on the right machine to the sensor head on
the right machine. To enter a measurement for a foot that falls
inside the laser face, place a negative sign (–) in front of it.
1/8 inch
(3 mm)
E
Center of outboard foot to center of inboard foot of the machine on
the right .
1/8 inch
(3 mm)
F
From right sensor head to center of coupling or, to the location
where offset tolerances are measured (this is not required for
jackshaft tolerances).
1/8 inch
(3 mm)