Manual Chapter 5

5-23

Foot Pre-Check

Loosen the hold-down bolt and wait for the dial to stop. Press any number

key to accept that value; the cursor will move to the next foot. Retighten

the bolt and proceed to the next foot. To remove results (clear data at a

single foot) and acquire new data, press Delete. To remove results at all feet

(clear data at all feet), press Alt/Delete.

After all feet have been checked (CSI recommends that you always check

all feet), press Enter and the data will be evaluated. The data is evaluated

based on the type of Foot Pre-Check being used. If Soft Foot is selected, the

data is evaluated as follows:

• “-----” – no measurement was made for this foot

• “OK” – the measurement to determine Soft Foot is within the speci-

ﬁed tolerance

• “x” – the measurement is from 1 to 2 times the speciﬁed tolerance

(1x tolerance < measurement ≤ 2x tolerance)

• “xx” – the measurement is from 2 to 3 times the speciﬁed tolerance

(2x tolerance < measurement ≤ 3x tolerance)

• “xxx” – greater than 3x tolerance

This method does not display a number as the machine is being checked

for soft foot (to prevent you from mistaking this number for a shim correc-

tion).