User's Guide

4. Set the device in the proper orientation.
Make sure that your planes are in the right direction. The Z plane should be vertical.
The orientation of the X and Y axis depends on how you configured your device.
To make sure that your X and Y axis stay where they are, use an allen wrench or a
small screwdriver while you torque down the device to make sure that everything
stays in the correct position. You can also hold the device while you torque it down.
5. Using a 3/16 in. Allen key, tighten the mounting screw over the device.
6. Insert and connect the battery.
7. Hold the device and then replace the cover. Tighten it.
3.5 Change the battery
The battery that comes with the device is replaceable. The battery may last without need
of replacement or recharge for a minimum of 3 years up to 5 years, if used at room
temperature while collecting and reporting with default collection parameters.
Note
While the device is approved for battery replacement in hazardous locations, always check
with your local Safety Officer before replacing the battery in a hazardous location.
Procedure
1. Using an allen wrench, hold the metal base.
2. Unscrew the device cover and then remove it.
3. Release the holding latch, and then carefully pull the battery tab to take the battery
out of the comparment.
4. Use your finger to release the bottom latch on the battery connect and then gently
pull it until the connector is released.
5. Plug the battery wire into the connector and position the wire so that it is held by
the battery clamp.
6. Place the battery into the compartment.
7. Snap the battery clamp back into place to secure the battery and wire.
8. Mount the cover and then tighten it. Tighten the cover all the way down until the
bottom of the cover touches the base.
Ensure that the base does not turn while tightening the cover.
Always ensure a proper seal when screwing the cover. The cover should be tightend
all the way down to the base to keep the device watertight and free from the
elements.
Installation
User Guide
July 2020 MHM-97927-PBF
44 MHM-97927-PBF, DRAFT