User's Manual
Table Of Contents
- Table of Contents
- 1. Overview
- 2. Quick Installation
- 3. Detailed Installation
- 4. Updates
- 5. Software Overview
- 6. Recording Wizard
- 7. Recording Options
- 8. Display Options
- 9. Reading a CATC Trace
- 10. Decoding Higher Protocols
- 10.1 Introduction
- 10.2 LMP and L2CAP Messages
- 10.3 Decoding and Viewing Higher Protocol Data
- 10.4 Tooltips
- 10.5 Viewing Packets in LMP and L2CAP Messages
- 10.6 Types of LMP and L2CAP Messages
- 10.7 Viewing L2CAP Channel Connections
- 10.8 Viewing Protocol Messages and Transactions
- 10.9 Changing Protocol Assignments
- 11. Other Features
- How to Contact CATC
- Warranty and License
- Index
137
BTTracer Protocol Analyzer User’s ManualCATC Version 1.0
You see the Timing and Bus Usage Calculator screen:
To calculate bus usage and bit rate errors,
Step 1 Enter the range of packets to be examined in the text boxes
marked "From packet" and "To packet."
Step 2 If you wish to limit your calculations to a single device,
select the device’s address from the AM Address drop-down
menu.
Step 3 Click the "Calculate" button.
At this point, bus usage will be calculated.
Traffic Summary
The Traffic Summary dialog box displays a text summary of traffic captured
in the current trace.
The Traffic Summary window divides into two main sections: a short top
section (shown above in the top left corner of the window) that summarizes
traffic for each protocol level, and a long section below describing the traffic
details for each protocol level.