User's Manual
Table Of Contents
- Table of Contents
- 1. Overview
- 2. Quick Installation
- 3. Detailed Installation
- 4. Updates
- 5. Software Overview
- 6. Recording Wizard
- 7. Recording Options
- 8. Display Options
- 9. Reading a CATC Trace
- 10. Decoding Higher Protocols
- 10.1 Introduction
- 10.2 LMP and L2CAP Messages
- 10.3 Decoding and Viewing Higher Protocol Data
- 10.4 Tooltips
- 10.5 Viewing Packets in LMP and L2CAP Messages
- 10.6 Types of LMP and L2CAP Messages
- 10.7 Viewing L2CAP Channel Connections
- 10.8 Viewing Protocol Messages and Transactions
- 10.9 Changing Protocol Assignments
- 11. Other Features
- How to Contact CATC
- Warranty and License
- Index
11
BTTracer Protocol Analyzer User’s ManualCATC Version 1.0
Step 2 Select the Modes tab.
The following dialog box will open showing factory default settings.
BTTracer defaults to “General Inquiry.” For this recording, leave most
of these settings unchanged. If you are recording a Hop Frequency that
is not 79 Hops Standard, you will need to select the appropriate
standard from the Hop Frequency menu below.
Step 3 Click OK to close the Recording Options window and
activate the recording options you selected.
At this point, BTTracer will be ready to record.
Step 4 Click on the Tool Bar.
BTTracer starts to record the Bluetooth™ traffic immediately. The
Bluetooth™ Inquiry process will proceed for 20 seconds. After 20
seconds has elapsed, the analyzer uploads the data and displays the
packets.
Step 5 If you wish to terminate the recording before the snapshot