User's Manual
Table Of Contents
- Table of Contents
- 1. Overview
- 2. Quick Installation
- 3. Detailed Installation
- 4. Updates
- 5. Software Overview
- 6. Recording Wizard
- 7. Recording Options
- 8. Display Options
- 9. Reading a CATC Trace
- 10. Decoding Higher Protocols
- 10.1 Introduction
- 10.2 LMP and L2CAP Messages
- 10.3 Decoding and Viewing Higher Protocol Data
- 10.4 Tooltips
- 10.5 Viewing Packets in LMP and L2CAP Messages
- 10.6 Types of LMP and L2CAP Messages
- 10.7 Viewing L2CAP Channel Connections
- 10.8 Viewing Protocol Messages and Transactions
- 10.9 Changing Protocol Assignments
- 11. Other Features
- How to Contact CATC
- Warranty and License
- Index
13
BTTracer Protocol Analyzer User’s ManualCATC Version 1.0
3. Detailed Installation
3.1 System Components/Packing List
• One stand-alone BTTracer Analyzer module
• One Antenna
• One External Interface Breakout Board with a 9-pin ribbon cable
• One 6-foot (2-meter) USB cable
• BTTracer software program installation CD and diskettes
• Product documentation
3.2 The Installed BTTracer Unit
The BTTracer Analyzer has several user-accessible controls and LEDs on
its front and rear panels of the OmniBus.
Figure 1: Front Panel
•RedPWR (power) indicator LED (lights when the unit power is
switched on).
•GreenREC (recording) LED (lights when the unit is recording).
• Yellow TRG (triggered) LED (lights when the unit triggers an event).
Note TRG also lights during power-on testing and will be turned off at the end of the
power on cycle. If the LED blinks at the end of this cycle, the hardware is faulty.
•GreenSYNC (synchronized) LED (lights when the unit is locked onto a
specific piconet, based on the Master Address).
• Manual Trigger push-button (allows a manual Trace capture)
— After beginning a recording session, press the Manual Trigger switch to
force a Trigger condition. The session completes when a specified
post-Trigger amount of bus data is recorded or when you manually stop a
recording session.
• ANT Bluetooth™ Antenna connector