User's Manual
Table Of Contents
- Table of Contents
- 1. Overview
- 2. Quick Installation
- 3. Detailed Installation
- 4. Updates
- 5. Software Overview
- 6. Recording Wizard
- 7. Recording Options
- 8. Display Options
- 9. Reading a CATC Trace
- 10. Decoding Higher Protocols
- 10.1 Introduction
- 10.2 LMP and L2CAP Messages
- 10.3 Decoding and Viewing Higher Protocol Data
- 10.4 Tooltips
- 10.5 Viewing Packets in LMP and L2CAP Messages
- 10.6 Types of LMP and L2CAP Messages
- 10.7 Viewing L2CAP Channel Connections
- 10.8 Viewing Protocol Messages and Transactions
- 10.9 Changing Protocol Assignments
- 11. Other Features
- How to Contact CATC
- Warranty and License
- Index
56
BTTracer Protocol Analyzer User’s ManualCATC Version 1.0
If you selected only the second option in Step 15 (=’Passive Sync &
Record’), the following screen will display.
This screen asks you for the address of the Page Target device -- which
in this case is BTTracer. Since the devices in your piconet are not able
to respond to inquiries, BTTracer will not be able to page the devices and
join the piconet. Instead, you will assign BTTracer an address here in
this screen, then direct your piconet Master device to connect to
BTTracer. The Master will attempt to connect to BTTracer and therein
give BTTracer the information it needs to record the Master and slave
devices.
Step 16 Type in an address of your choosing for BTTracer (= Page Target).
You are making up an address for BTTracer that the Master will use to
try to connect to BTTracer.