User's Manual

69
BTTracer Protocol Analyzer User’s ManualCATC Version 1.0
•79 Hops Standard
• 23 Hops J
apan
• 23 Hops Spa
in
• 23 Hops Franc
e
• Reduced Hop - Restricts BTTracer to five hop frequencies
defined in the test mode specification of the Bluetooth™
Specification. When Reduced Hop or Single Frequency is
selected, the Sync method is set to Test Mode and cannot be
modified by the user.
• Single Frequency - Allows the the transmit and receive frequency
ranges to be specified. Selecting this option highlights the "DUT
Xmit" and "DUT Recv" text boxes. When Reduced Hop or
Single Frequency is selected, the Sync method is set to Test Mode
and cannot be modified by the user.
• Enter values into the two text boxes to the set the transmit and
receive frequency ranges:
• DUT Xmit Freq, MHz (+2402) – Allows the setting of the
transmit signal for the Device Under Test
• DUT Recv Freq, MHz (+2404) – Allows the setting of the
receive signal for the Device Under Test
Sync Methods
Note If the selected Hop Sequence is "Reduced Hop" or "Single Frequency," the Sync
Method is set to "Test Mode" and cannot be modified by the user.
Page Sync & Record
"Page Sync and Record" is the recommended method of recording. "Page
Sync and Record" should be implemented before a piconet is established.
This mode causes BTTracer to perform a General Inquiry and collect sync
information from the specified slave device when it responds. BTTracer
then waits for the Master to begin paging the Slave devices. When paging
begins, BTTracer synchronizes to the Master and begins recording.
Note In order for this mode to work, the intended Slave must support "inquiry scan".
The following steps describe the simplest way to use this mode:
Step 1 Place both the "intended master" as well as its first "intended slave"
into inquiry scan mode.