User's Manual
Table Of Contents
- Table of Contents
- 1. Overview
- 2. Quick Installation
- 3. Detailed Installation
- 4. Updates
- 5. Software Overview
- 6. Recording Wizard
- 7. Recording Options
- 8. Display Options
- 9. Reading a CATC Trace
- 10. Decoding Higher Protocols
- 10.1 Introduction
- 10.2 LMP and L2CAP Messages
- 10.3 Decoding and Viewing Higher Protocol Data
- 10.4 Tooltips
- 10.5 Viewing Packets in LMP and L2CAP Messages
- 10.6 Types of LMP and L2CAP Messages
- 10.7 Viewing L2CAP Channel Connections
- 10.8 Viewing Protocol Messages and Transactions
- 10.9 Changing Protocol Assignments
- 11. Other Features
- How to Contact CATC
- Warranty and License
- Index
81
BTTracer Protocol Analyzer User’s ManualCATC Version 1.0
Header Length Error
Indicates that a received Bluetooth™ data packet was terminated before all
bits of the packet header were received.
Payload Length Error
Indicates that the payload of a received Bluetooth™ data packet was either
longer than expected, or that a Bluetooth™ data packet terminated before
the expected end of the payload data.
Sync Loss
When set, indicates that a loss of piconet synchronization occurred during
the frequency slot prior to this slot.
External Input Signals
Clicking "External Input Signals" causes two check boxes to appear for
setting conditions based on breakout board input signals. The names of the
two check boxes are the same ones you will find on the break out board:
• Trigger Input [TRIG IN]
• General Purpose Input [G.P. IN]