User's Manual

83
BTTracer Protocol Analyzer User’s ManualCATC Version 1.0
This center section can also hold Event buttons such as Errors and Payload
Hdr1. Event buttons in this section are used to create triggers based on a
sequence of Events. Event Sequencing is explained later in the chapter.
The right section has three permanent buttons for setting actions. These
buttons are Trigger, Filter Out/In,andRestart. These buttons allow you
to set actions such as triggering or filtering.
Arrows connect Event, Counting, and Action buttons. Arrows represent
the current associations between actions and events. As will be described
further on, these associations can be easily changed with the mouse.
Action Buttons - Their Functions
The Action buttons in the right side of the window provide the means of
setting triggers, filters, and restarts. To set an action, you simply drag your
mouse from an Event to an Action. As described further on, this movement
will link the two via an arrow.
Trigger
The Trigger button enables event triggering.
Filter In/Out
The Filter In/Out button allows events to be filtered in or out of the
recording.
Restart
The Restart button causes the two counters Count1 and Count2 to be reset
to zero.
Counting Buttons - Their Functions
The center section of the Actions window has two buttons for counting
events called Count1 and Count2. Below these buttons, you can add Event
buttons to create Event Sequencing.
Count1, Count2
Count1 and Count2 are counters for specifying how many events must occur
before an event can cause a trigger. Counters allow conditions to be made
such as "Trigger after the 21st Poll packet" (see screenshot below).