USER’S GUIDE COLOR MONITOR Model No : 910TF CTL S/N : 9978626520
IMPORTANT SAFEGUARDS 1. Read all of these instructions. 2. Save these instructions for later use. 3. Unplug this monitor from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. 4. Do not use attachments not recommended by the monitor manufacturer as they may cause hazards. 5. Do not use this monitor near water, e.g., near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, etc. 6.
CONTENTS Introduction ............................................................................. 1 Product Features ................................................................. 2 Setup ......................................................................................... 3 Connecting the Signal Cable and Power Cord..................... 3 Operation & Adjustment ...................................................... 4 Specifications ..................................................................
PRODUCT FEATURES • The convenient and user-friendly on-screen display allows for easy and accurate adjustments of horizontal and vertical screen size and position, geometry and screen color. • The monitor supports a safe working environment in strict compliance with the MPR II standard for low emissions. • The monitor complies with the VESA Display Data Channel (DDC) specification for Plug and Play compatibility. Advanced microcircuitry makes setup and configuration fast and effortless.
OPERATION & ADJUSTMENT Key Process Control Panel ENGL SH DEUTSCH ESPAÑOL FRANCA S TAL ANO • Move cursor to the right window on the OSD window. • Increase the value of any selected function. • Move cursor to the left window on the OSD window. • Decrease the value of any selected function. • Launch OSD(On-Screen Display) MENU window. MENU • Move cursor to the high window on the OSD window. • Increase the value of V.size or V.center. • Move cursor to the low window on the OSD window.
OSD Functions ICON ICON CONTROL FUNCTION CONTROL FUNCTION H. MOIRE Adjust the horizontal picture moire cancellation. V. MOIRE Adjust the vertical picture moire cancellation. FOCUS Adjust the focus image. ZOOM Adjust the display width & height at the same time. PINCUSHION Adjust the left and right margins for more convex or more concave margins. TRAPEZOID Adjust the trapezoid of the screen by moving the lines inward or outward.
SPECIFICATIONS ICON CONTROL FUNCTION STATUS Display horizontal & vertical frequency and polarity. POWER SAVER YES : VESA DPMS operation. NO : NO DPMS operation. TEST PATTERN Display a RGB Color Bar to determine whether the screen color is expressed normally or not. RECALL Reset the screen to the Factory Preset Display Settings. Self Diagnosis When the monitor doesn’t display, if you press any key, Self Diagnosis screen is displayed.
DESCRIPTION FOR D-SUB CONNECTOR TROUBLESHOOTING Symptom No picture. Check Check if power switch and computer power switch are in the on position. Check if the signal cable is correctly connected to the video card. Check if the pins of D subconnector are not bent. Check if the computer is in the power- saving mode. POWER LED is not Check if power switch is in the on position. lit. Check if the power cord is correctly connected. Image is unstable. Check if the signal cable is suitable to the video card.