User Manual

The transmitter module in each device shall have the following label. Use only products that

bear this label and do not remove the label from the modules that it is attached to. Do not

modify modules or attempt to service the module at any time. Part replacements shall only

be done through Computerized Security Systems, Inc.

Transmitter Module FCC ID: SAPMESSENGER

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Installation

Attach the Saflok door locks to the doors and test for normal operation with an opening key.

(Refer to the Saflok MT Lock Installation and Programming Guide.)

Install the Messenger transceiver hubs in the locations identified by the site survey floor plan.

Each hub location will have a static IP address. Record the IP address for each hub on the

floor plan in the appropriate location representing that hub’s location.

Connect the Messenger transceiver hubs to the Ethernet network and then to power, using the

power supply provided. (See Figure 4)

Verify that all installed transceiver hubs are properly connected via Ethernet to the host

computer by running the utility “Find Hub” from the Messenger host PC. (Refer to the

Saflok Messenger Database Function Manual.)

Turn on the lock radios by inserting and removing the “Radio On” key into each lock. The

door locks will then automatically associate with a close proximity transceiver hub. If more

than one hub is within range, the door lock radio will associate with the first transceiver hub

that responds, even if it is not the closest hub. Once the lock associates with the transceiver

hub, the transceiver hub will use the Ethernet to notify the server that it is the controlling hub

for that lock, and all messages initiated by the host will pass through the appropriate

transceiver hub to get to the intended lock.

Operate the locks with a master key. The use of the master key will appear on the server’s

screen within a short period of time, verifying the locks connection to the server.