User's Manual

ManualsBrandsComputerized Security Systems ManualsElectronicsRFID card reader used to access security devices

Quantum™ RFID Pg. 1 of 6

Outside Lever Trim

(A20970-HAND-COLOR)

Mortise Lock

(A59810-HAND-G)

Mortise, Std.

(A59850-HAND-G)

Mortise, ADB

(A60000-HAND-G)

Mortise, MT, STD, DAJ

(A59990-HAND-G)

Mortise, MT, ADB, DAJ)

Scalp Plate

(51190-COLOR)

Strike Plate

(30320-HAND-COLOR)

Inside Trim Assembly

(QP12XXX-6-XX)

Quantum

™

RFID

Installation Instructions

All parts needed to install the Quantum™ RFID lock are included with each unit. Please check to make

sure all parts are accounted for before beginning installation. Do not substitute any of the parts. The use

of substitute parts will result in poor performance of the lock.

All information contained herein, including but not limited to product pricing and other intellectual property, is confidential and

intended for the sole use of the addressee(s) so named. Any misuse of this confidential information contained herein may result in

legal action by Computerized Security Systems dba SAFLOK and its parent company.

Screw Pack

(A29050-COLOR)

Proximity Reader Assembly

(A20910-COLOR)

Gear Box

For the standard

mortise only

(24012-1)

Summary of content (6 pages)

PAGE 1
Quantum™ RFID Pg. 1 of 6 Quantum™ RFID Installation Instructions All parts needed to install the Quantum™ RFID lock are included with each unit. Please check to make sure all parts are accounted for before beginning installation. Do not substitute any of the parts. The use of substitute parts will result in poor performance of the lock.
PAGE 2
Quantum™ RFID Pg. 2 of 6 Preparing the door and door frame 1. Prepare the door using the Quantum RFID installation template or drill fixture. The door edge prep is a standard, full-mortise prep for a 1-1/4” x 8” front plate (1” x 8” and 1” x 7-3/4” custom front plates are optional). The door surface holes and mortise are customized for the SAFLOK trim. Important: Some holes are only on the inside surface of the door.
PAGE 3
Quantum™ RFID Pg. 3 of 6 Installing the lock trim The outside lever trim has two carriage bolts that fit into the diagonal holes in the mortise case. These carriage bolts establish an accurate trim position with respect to the mortise case assembly, allowing the levers and bolt mechanism to operate without binding. The holes machined in the door surfaces should not influence the position of the trim or the proximity reader assembly.
PAGE 4
Quantum™ RFID Pg. 4 of 6 Installing the lock trim (continued) 10. Watching for the green LED on the proximity reader to flash four times, connect the battery wire to the PCB. The green light indicates that the PCB has reset. Important: The battery wire should be the last connection made to the PCB. 11. With the dead bolt retracted, insert the long end of the dead bolt spindle assembly through the PCB switch cam hole and into the mortise dead bolt hub.
PAGE 5
Quantum™ RFID Pg. 5 of 6 Testing Lock Functionality Pass a Construction key over the Quantum RFID LPI probe. Be sure that the green light flashes for five seconds while the exterior lever remains operable. If the green light does not flash, refer to the table below.
PAGE 6
Quantum™ RFID Pg. 6 of 6 Electronics/Keycards Keycard can be inserted and withdrawn freely Yellow light flashes twice when incorrect keycard is used Red light flashes twice if keycard is used incorrectly and cannot be read (e.g.