User's Manual

CT-EM2606 ZigBee Ready RF Transceiver Modules

17. Product Approvals

17.1 FCC Approvals

The CT-EM2606 has been designed to meet all national regulations for World-wide use.

Using the integrated antenna it conforms to FCC CFR 47 Part 15 (USA).

This device complies with Part 15 of the FCC rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

The device CT-EM2606 carries FCC authorization and is marked with the FCC ID

Number. Whilst any device into which this authorized module is installed will not normally

be required to obtain FCC authorization, this does not preclude the possibility that some

other form of authorization or testing may be required for the finished device.

When the CT-EM2606 module is integrated inside another device/product, then the

outside surface of that device/product must display a label referring to the enclosed

module. This exterior label can use wording such as “Contains Transmitter Module

FCC ID:DICT-EM2606” or “Contains FCC ID: DICT-EM2606”

, although any similar

wording that expresses the same meaning may be used.

To meet the Section 15.209 emission requirements in the restricted frequency

bands of Section 15.205, the transceiver transmitter power for the CT-EM2606

module needs to be reduced from the typical maximum setting on the upper two

channels (2475 MHz and 2480 MHz). Maximum values are TBD.

FCC statement：

If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.