Installation manual

MNC-0400-001 32 of 54 REV H
Operation, Rack and Digital HPAs
Setup Menu 3
Setup Menu 3 allows you to:
• Set the time and date used for alarm and fault recording.
• Select linearizer, if installed, and adjust phase and amplitude.
• Select band.
Setup Menu 3, Figure 12 provides access to the Time/Date
Menu, the Linearization Menu, the Calibrate Attenuator Menu,
and Setup Menu 4.
[Softkey 1]—Press to access the Time/Date Menu
[Softkey 2]—If Linearizer is installed, press to access the
Linearization Menu
[Softkey 3]—If HPA is multi-band, press to access the Select
band Menu
[Softkey 4]—Press to access Setup Menu 4
Time/Date Menu
[Softkey 1]—Time value on line to the left of this soft key is the
current time: hh:mm:ss. Press to allow entry of new time.
[Softkey 2]—Date value to the left of this softkey is the current
date: yy/mm/dd. Press to allow entry of new date.
[Softkey 3]—Not used. Value entered for the new value on the
numeric keypad shows up to the left of the soft key. Press
[Enter] to accept your entry. Press [Clear] to clear your entry.
[Softkey 4]—Back. Return to Setup Menu 3
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.