Installation manual

MNC-0400-001 33 of 54 REV H
Operation, Rack and Digital HPAs
Figure 12, Setup Menu 3
Setup Menu 4
Setup Menu 4, Figure 13provides access to the Configure
COM1, Configure COM2, Set System Address sub-menus, and
Setup Menu 5 which is used to Calibrate Attenuator and
Replace Firmware.
[Softkey 1]—Accesses the Configure COM1 Menu.
[Softkey 2]—Accesses the Configure COM2 Menu.
[Softkey 3]—Accesses the Set System Address Menu.
[Softkey 4]— Accesses Setup Menu 5.
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.