Product specifications

Ku-Band Satellite Transceiver Revision 9
FSK Remote Control Commands MN/KST2000AB.IOM
E-8
Parameter
Type
Command
(Instruction
Code and
qualifier)
Arguments for
Command or
Response to
Query
Description of arguments
(note that all arguments are ASCII numeric codes, that is, ASCII
codes between 48 and 57)
Response to Command (target to
controller)
Query
(Instruction
Code and
qualifier)
Reference
Frequency Adjust
REF= 3 bytes Command or Query.
<add/REF=nnn’cr’
>add/REF=’cr’’lf’
<add/REF?’cr’
>add/REF=nnn’cr’’lf’
Where: nnn = 000 to 255
REF= (message ok)
REF? (received ok, but invalid arguments
found)
REF* (message ok, but not permitted in
current mode)
REF?
Set Physical
Address
SPA= 3 bytes Command or Query.
<add/SPA=xxx’cr’
>add/SPA=’cr’’lf’
<add/SPA?’cr’
>add/SPA=xxx’cr’’lf’
Where: xxx = new address
SPA= (message ok)
SPA? (received ok, but invalid argument
found)
SPA* (message ok, but not permitted in
current mode)
SPA?
LNA Calibrated CAL= None Command only.
<add/CAL=’cr’
>add/CAL=’cr’’lf’
Calibration to allow system to determine nominal LNA power
consumption, performed at initial installation only.
Note: Not applicable for a TX only system
CAL= (message ok)
CAL? (received ok, but invalid argument
found)
CAL* (message ok, but not permitted in
current mode)
n.a.
LNA Power
Enable
LCS= 1 byte Command or Query.
<add/LCS=x’cr’
>add/LCS=’cr’’lf’
<add/LCS?’cr’
>add/LCS=x’cr’’lf’
Where: x = 0 (Off)
1 (On)
LCS= (message ok)
LCS? (received ok, but invalid argument
found)
LCS* (message ok, but not permitted in
current mode)
LCS?
LNA Fault
Enable
LFL= 1 byte Command or Query.
<add/LFL=x’cr’
>add/LFL=’cr’’lf’
LFL= (message ok)
LFL? (received ok, but invalid argument
found)
LFL?