Product specifications

UT-4500A Series Upconverters Revision 0
Introduction MN-UT4500A
1–14
1.4.4 UT-4514-A, /C-A, /D-A, /E-A, /F-A Upconverters
Characteristic Specification
Frequency Range UT-4514-A 14.00-14.50 GHz
UT-4514/C-A 12.75-13.25 GHz
UT-4514/D-A 13.75-14.50 GHz
UT-4514/E-A 14.70-15.00 GHz
UT-4514/F-A 12.75-14.50 GHz
Conversion Dual, No Inversion
Step Size 125 kHz
Preset Channels 32 Frequencies and Gains
Stability over Time ± 1 x 10
-9
/Day
Stability over Temp ± 1 x 10
-8
0-50°C (32-122°F)
RF Output Output Level +20 dBm at 1 dB Compression
Intermodulation -60 dBc @ 0 dBm Output SCL
Carrier Mute -70 dBc
Non-carrier Spurious -80 dBm
Carrier Spurious -65 dBc @ 0 dBm Output
AM to PM 0.1
o
. / dB at –5 dBm Out
Return Loss 20 dB Minimum with RF/IF Connector Module
18 dB Minimum with Switch Module
Impedance
50"
IF Input Noise Figure 13 dB Maximum at 0 dB Attenuation
Level -35 dBm Typical
Range 52-88 or 104-176 MHz (optional 50-80 MHz or 100-180 MHz – see *Note)
Impedance
50" or 75"
Return Loss 23 dB Minimum with RF/IF Connector Module or Switch Module
Transfer Gain 35 dB ± 2 dB
Gain Adjust 0-25 in 0.25 dB Steps
Gain Stability ± 0.25 dB/Day
Ripple ±0.25 dB
Slope 0.05 dB/MHz
Image Rejection -80 dB Inband
External Reference 5 or 10 MHz, +3 dBm Nominal
Group Delay Linear Group Delay 0.03 ns/MHz
Parabolic Delay 0.01 ns/MHz
2
Group Delay Ripple 1.0 ns Peak-to-Peak
Phase Noise Parameter Limit (dBc/Hz) Typical (dBc/Hz)
100 Hz -72 -79
1 kHz -79 -82
10 kHz -89 -92
100 kHz -98 -101
1 MHz -110 -114