Product specifications

UT-4500-A Series Upconverters Revision 0
Installation MN-UT4500A
2–3
2.2.2 Installation using Optional Rear-Mounting Support Brackets
Install optional rear-mounting support brackets using kits KT/6228-2 or KT/6228-3:
Quantity
Part Number Description
KT/6228-2 KT/6228-3
2 2 HW/10-32SHLDR Screw, #10 Shoulder
4 4 HW/10-32FLT Washer, #10 Flat
2 2 HW/10-32SPLIT Washer, #10 Split
2 2 HW/10-32HEXNUT Nut, #10 Hex
4 4 HW/10-32x1/2RK Bolt, #10 Rack Bracket
2 – FP/6138-2 Bracket, Rear Support – 4”
– 2 FP/6138-3 Bracket, Rear Support – 10”
The tools required for this installation are a medium Phillips# screwdriver, a 5/32-inch SAE
Allen# Wrench, and an adjustable Crescent
®
wrench.
The kit is installed as illustrated in Figure 2-2 v
ia the following procedure:
Step Procedure
1
Secure the #10 shoulder screws to the unit chassis through the rear right and left side
mounting slots, using the #10 flat washers, #10 split washers, and #10 hex nuts as
shown.
2
Install the rear support brackets onto the equipment rack threaded rear mounting
rails, using the #10 rack bracket bolts.
3
Mount the unit into the equipment rack, ensuring that the #10 shoulder screws properly
engage into the slots of the rear support brackets.
Figure 2-2. Optional Rear-Mounting Support Brackets Installation