Product specifications

UT-4500-A Series Upconverters Revision 0
Front Panel Operation MN-UT4500A
5–14
03625.125 MHz 01.25 dB !
The user may create (program) up to 32 operating configurations, and recall them as needed. If
any pre-selects exist, use the # $ arrow keys browse through the available pre-selects (i.e., #01
through #32), and then press ENTER.
Note: Upon initial selection – i.e., prior to the creation of any pre-selects – this menu branch
appears as follows:
#XX LOAD PROGRAM CLEAR
No Pre-Select Programmed
Use the ! " arrow keys to select one of the following actions, and then press ENTER.
Selection Functional Description
LOAD
Recalls a previously defined pre-select from memory.
PROGRAM
Stores a defined set of operating parameters into memory for future recall.
CLEAR
Clears a previously defined pre-select from memory.
5.3.4.1 PRE-SELECTS: LOAD
Load this pre-select
Into converter? No Yes
LOAD is operable when pre-selects have previously been programmed into the unit via the
PROGRAM submenu. Use the
! " arrow keys to select No or Yes, and then press ENTER.
5.3.4.2 PRE-SELECTS: PROGRAM
Program pre-select? #XX
04200.000 MHz 01.25 dB
Select PROGRAM when it is desired to save an operational configuration for recall at a later
date.
On the top line, first use the
! " arrow keys to navigate to the pre-select designator (#XX), and
then use the # $ arrow keys to select a number from 01 to 32.
The read-only bottom line displays the operating parameters that will be stored into the designated
slot (via this submenu), and then recalled via the LOAD submenu.
5.3.4.3 PRE-SELECTS: CLEAR
Clear this pre-select?
No Yes