Product specifications

UT-4500-A Series Upconverters Revision 0
Appendix A MN-UT4500A
A–13
Command Details
Application ID: <DEV/AID_xxxxxxx ... xxxxx'cr'
Confirmation: >DEV/AID_'cr'
xxxxxxxxxxxxxxxxxxxxxxxx'cr'
xxxxxxxxxxxxxxxxxxxxxxxx'cr''lf']
Retrieve ID: <DEV/AID_'cr'
Confirmation: >DEV/AID_'cr'
xxxxxxxxxxxxxxxxxxxxxxxx'cr'
xxxxxxxxxxxxxxxxxxxxxxxx'cr''lf']
Note: xxxxxxx ... xxxxx = Your message, maximum 48 characters.
A.7.1.22 Force Reboot
The FRB command allows the unit to be forced to reboot after five seconds. This value is write-
only.
Command Details
Force Reboot: <DEV/FRB_YES'cr'
Confirmation: >DEV/FRB_YES'cr''lf']
A.7.2 Configuration Commands
A.7.2.1 Frequency
The default RF frequency of the unit is equal to its minimum operating frequency (RF
Low
).
Command Details
Set Frequency: <DEV/FRE_xxxxx.xxx'cr'
Confirmation: >DEV/FRE_xxxxx.xxx'cr''lf']
Retrieve Frequency: <DEV/FRE_'cr'
Confirmation: >DEV/FRE_xxxxx.xxx'cr''lf']
Note: For example, xxxx.xxx = 14000.000 to 14500.000 MHZ in 125 KHz steps for Model
UT
-
4514-A
A.7.2.2 Attenuator
The default attenuation value is 10.00 dB.
Command Details
Set Attenuator: <DEV/ATT_ yy.yy'cr'
Confirmation: >DEV/ATT_yy.yy'cr'lf']
Retrieve Attenuator: <DEV/ATT_'cr'
Confirmation: >DEV/ATT_ yy.yy'cr''lf']
Note: yy.yy = 00.00 to 25.00 dB in 0.25 dB steps.