Product specifications

UT4500 Series Up Converter MN/UT4500.IOM

Remote Control Revision 2

5.6.2.8 CLEAR PRESET

This command is used to clear a preset number.

Command Details

Clear a Preset: <DEV/CLR_nn'cr'

Confirmation: >DEV/CLR_nn_Cleared'cr''lf']

Note: nn = Preset Number = 01 to 32.

5.6.2.9 SELECT A PRESET

This command is used to configure the converter to the frequency and attenuation data

assigned to a given preset number.

Command Details

Select Preset: <DEV/SEL_nn'cr'

Confirmation: >DEV/SEL_nn_Selected'cr''lf']

Note: nn = Preset Number = 01 to 32.

Only programmed preset numbers are available.

5.6.3 MODES

There are two modes of operation that may intersect: Redundant Mode and Automatic

Mode.

5.6.3.1 REDUNDANCY MODE

Since the default mode is OFF, each converter including the backup converter

must be commanded into the Redundancy Mode.

Polling on the high speed bus will not begin until the position assignments are

made.

Command Details

Redundancy Mode: <DEV/RED_xxx'cr' xxx = ON or OFF

Confirmation: >DEV/RED_xxx'cr''lf']

Redundancy Status: <DEV/RED_'cr'

Confirmation: >DEV/RED_xxx'cr''lf']

Each converter's chain position must be initialized including the backup converter. The

following redundancy initialization command is only allowed if Redundancy Mode has

been selected.