Product specifications

UT4500 Series Up Converter MN/UT4500.IOM

Remote Control Revision 2

5.8 CONVERTER REMOTE COMMAND SUMMARY

Table 14. Remote Command Summary

Utility Commands Paragraph

Set Time <DEV/TIM_hh:mm:ss'cr' 5.6.1.1

Set Date <DEV/DAT_mm/dd/yy'cr' 5.6.1.2

Set Physical Address <DEV/SPA_xxx'cr' 5.6.1.3

Set Baud Rate <DEV/SBR_xxxx'cr' 5.6.1.4

Set LCD Contrast <DEV/CON_xx'cr' 5.6.1.5

Set LCD Brightness <DEV/LCD_xx'cr' 5.6.1.6

Set Reference Oscillator

<DEV/SRO_xxx'cr'

5.6.1.7

Set Converter Slope Adj. <DEV/SSA_xxx'cr' 5.6.1.8

Retrieve Equipment Type <DEV/RET_'cr' 5.6.1.9

Retrieve Firmware Information <DEV/FRW_'cr' 5.6.1.10

Set Application ID Message <DEV/AID_xxxxx...xxxxx'cr' 5.6.1.11

Configuration Commands Paragraph

Set Frequency <DEV/FRE_xxxxx.xxx'cr' 5.6.2.1

Set Attenuation <DEV/ATT_xx.xx'cr' 5.6.2.2

Select Cold Start Mode <DEV/CLD_xxx'cr' 5.6.2.3

Mute/Unmute Converter <DEV/MUT_xxx'cr' 5.6.2.4

Select Auto Fault Recovery Mode <DEV/AFR_xxx'cr' 5.6.2.5

Program a Preset <DEV/PGM_nn_xxxxx.xxx_yy.yy'cr' 5.6.2.6

Display All Presets <DEV/DPS_'cr' 5.6.2.7

Clear a Preset <DEV/CLR_nn'cr' 5.6.2.8

Select a Preset <DEV/SEL_nn'cr' 5.6.2.9

Redundancy Mode Commands Paragraph

Select Redundancy ON/OFF <DEV/RED_xxx’cr’ 5.6.3.1

Configure Redundant Converter <DEV/ICT_xx_yy’cr’ 5.6.3.1

Select Auto/Manual Mode <DEV/SAM_xx_y'cr' 5.6.3.2

Forced Backup Mode <DEV/FBU_xx_y'cr' 5.6.3.3