Product specifications

CDD-562L/564 Demodulator with IP Module Revision 1
Rear Panel Connector Pinouts MN/CDD564L.IOM
3–3
3.3 Terrestrial Data Connection
3.3.1 10/100 BaseT Ethernet Management Port Connector (M&C), RJ-45
The 10/100 Ethernet connector is a standard 8-pin RJ-45 modular jack,
used for connecting a UTP cable to an Ethernet switch or hub. This
interface is a Network Interface Card (NIC) pinout, used for Ethernet
traffic, management of CDD-562L/564/564L IP Module functions via
Telnet/HTTP/ SNMP, and upgrading of the demodulator’s IP Module
software. Observe the following:
Pin # Function
1 Tx+
2 Tx-
3 Rx+
4 N/C
5 N/C
6 Rx-
7 N/C
8 N/C
3.4 Utility Connections
3.4.1 Remote Control Interface Connector, DB-9M
IMPORTANT
This connector is
NOT intended for customer use. Contact CEFD Customer
Support prior to connecting any equipment to this interface.
The Remote Control Interface Connector is a 9-pin Type ‘D’ male connector.
Note: This interface is NOT a standard EIA-232 interface, and it is NOT
intended for customer use – it is intended for Factory Test use only. Observe
the following:
Pin # Description Direction
1 Ground --
2 EIA-232 Transmit Data (38.4k, 8N1 fixed) Out
3 EIA-232 Receive Data (38.4k, 8N1 fixed) In
4 Selected Demod I-Channel monitor Out
5 Selected Demod Q-Channel monitor Out
6 Selected Demod RS-422 Rx Data + In
7 Selected Demod RS-422 Rx Data - In
8 Selected Demod RS-422 Tx Clock + Out
9 Selected Demod RS-422 Tx Clock - Out