Operation Manual

33
To exchange battery pack, slide open the battery door in direction as shown,
take out the battery pack and disconnect from socket.
2. Operation from AC mains using the charger stand
Connect the output plug of supplied 6V AC adapter to DC jack 16 of charger
stand, make sure the polarity is correct. With the unit being switched on,
place it into the charger stand. The charging indicator 17 should light up red.
Adjust the position of unit in case the indicator 17 does not light up. During
charging, the power indicator 3 will have both red and green colour light up.
Once the battery is fully charged up (normally it takes around 4 hours), the
indicator 3 turns steady green only. Either you can take the unit out or
keeping placing it in the charger stand will cause no damage to the battery.
In the latter case, when the battery is being consumed and voltage falls to a
certain level, the charger stand will automatically start charging up the
battery again.
Note: Before using the parent unit for the first time, charge up the Li polymer
battery for at least four hours.
CAUTION: BESURE THE BATTERY IN THE PARENT UNIT IS
RECHARGEABLE TYPE BEFORE PLACING IT IN THE CHARGER
STAND, OTHERWISE EXPLOSION MAY RESULT.
16
3
17
CT-2400_Manual_04.pdf 33 28/4/14 6:03 pm