Operation Manual

short press

short press short press

short press

short

press

OFF

Night light ON

Intensity level 1

vox

Intensity level 3

Night light ON

Intensity level 2

Night light ON

Intensity level 3

3. Once BU is in transmit mode, the transmit indicator 10 will light up red. The

unit will return standby mode a few seconds after the microphone 12 stops

picking up any sound and the transmit indicator 10 goes off.

4. The night light 14 can be set to permanently ON or vox (voice activated) by

short press of the button 11 in following manner:

Under VOX mode, the night light vox indicator 15 will light up. Once the

microphone 12 picks up a sound, the night light 14 will be turned on and will

fade off automatically a few seconds after the microphone 12 stops picking

up any sound.

Parent unit (PU)

1. Switch on the unit by long press of button 1. The power indicator 3 will

show steady green. If this indicator starts flashing green, the battery level

becomes low.

Either replace with new battery or change using the supplied AC adapter as

power supply. (For PU equipped with Li battery, place it inside the supplied

charger stand to charge up the battery).

The LED level meter 4 will show the battery status for around 3 sec whenever

the power is switched on, then it resumes to show the received signal level

from baby unit.

Under normal operation, short press of the button 1 at any time will show the

battery status on the LED level meter 4.

2. Place the PU at a reasonable distance away from BU to avoid feedback. Too

close a distance will create a screeching sound at the speaker 5.

3. Once the PU receives a signal, the LEDs in the level meter 4 will light up.

The louder the baby’s voice, the more number of LED will be lighted up. This

feature is useful to alert the parents of baby’s cry in case the volume of

speaker 5 is turned low to keep the environment quiet,

4. The speaker volume can be adjusted using the button 2. The LED level

meter 4 will show the setting. More LEDs light up means higher volume

(maximum 5 LED).

CT-2400_Manual_04.pdf 36 28/4/14 6:03 pm