User's Manual

Blocking Mode: In blocking mode, the multicast data traffic will be

blocked and not flood to all bridge ports when there are

no client subscriptions to any multicast group.

Enable LAN side firewall: Enable by ticking the checkbox .

DHCP Server: To enable DHCP, select Enable DHCP server and enter Start and

End IP addresses and the Leased Time. This setting configures the

router to automatically assign IP, default gateway and DNS server

addresses to every PC on your LAN.

Static IP Lease List: A maximum of 32 entries can be configured.

To add an entry, enter MAC address and Static IP and then click Save/Apply.

To remove an entry, tick the corresponding checkbox  in the Remove column and

then click the Remove Entries button, as shown below.

DHCP Server Relay: Enable with checkbox  and enter DHCP Server IP address.

This allows the Router to relay the DHCP packets to the

remote DHCP server. The remote DHCP server will provide

the IP address. This option is hidden if NAT is enabled

or when the router is configured with only one Bridge

PVC.

LAN INTERFACE

To configure a secondary IP address, tick the checkbox  outlined (in RED) below.