User's Manual

85
Click Apply/Save to save and activate the rule.
Field
Description
Traffic Class Name
Enter a name for the traffic class.
Rule Order
Last is the only option.
Rule Status
Disable or enable the rule.
Classification Criteria
Class Interface
Select an interface (i.e. Local, eth0-4, wl0)
Ether Type
Set the Ethernet type (e.g. IP, ARP, IPv6).
Source MAC Address
A packet belongs to SET-1, if a binary-AND of its source MAC
address with the Source MAC Mask is equal to the binary-AND of
the Source MAC Mask and this field.
Source MAC Mask
This is the mask used to decide how many bits are checked in
Source MAC Address.
Destination MAC Address
A packet belongs to SET-1 then the result that the Destination MAC
Address of its header binary-AND to the Destination MAC Mask
must equal to the result that this field binary-AND to the
Destination MAC Mask.
Destination MAC Mask
This is the mask used to decide how many bits are checked in
Destination MAC Address.
Classification Results
Specify Class Queue
Packets classified into a queue that exit through an interface for
which the queue is not specified to exist, will instead egress to the
default queue on the interface.
Specify Class Policer
Packets classified into a policer will be marked based on the
conforming action of the policer
Mark Differentiated
Service Code Point
The selected Code Point gives the corresponding priority to packets
that satisfy the rule.
Mark 802.1p Priority
Select between 0-7.
Set Rate Limit
The data transmission rate limit in kbps.