User's Manual

Table Of Contents

3.3 Login Procedure

Perform the following steps to login to the web user interface.

NOTE: The default settings can be found in 3.1 Default Settings.

STEP 1: Start the Internet browser and enter the default IP address for the device in the Web

address field. For example, if the default IP address is 192.168.1.1, type

http://192.168.1.1.

NOTE: For local administration (i.e. LAN access), the PC running the browser must be attached

to the Ethernet, and not necessarily to the device.

For remote access (i.e. WAN), use the IP address shown on the Chapter 4 Device

Information screen and login with remote username and password.

STEP 2: A dialog box will appear, such as the one below. Enter the default username and

password, as defined in section 3.1 Default Settings.

Click OK to continue.

NOTE: The login password can be changed later (see 8.6.1 Accounts).

STEP 3: After successfully logging in for the first time, you will reach this screen.