User Manual

Step 2 - Placement and connections

A. Setting an AP device

Using a power supply with different voltage rating than the one

included with the WAP-5836 device may cause damage and

void the warranty for this product.

1. Place one WAP-5836 device on an easily accessible surface near the

Home Gateway or Router. Make sure the GW or Router is powered on and

active.

2. Plug one end of the Ethernet cable into the LAN port of the Home Gateway

device and the other end into the Ethernet port of the WAP-5836.

3. Ensure that the DHCP

Server functionality on your

Home Gateway or Router is

enabled. The WAP-5836

device that gets a DHCP IP

Address will be automatically

set in Access Point (AP)

mode for a simplified setup

process.