User Manual

Pairing

Step 1. Pair the devices:

For initial pairing, it is recommended that you place the WAP-5836 AP and

Client devices within the same room. Once paired, they can then be put in

their desired locations.

Press the WPS button on the “AP” front panel for

3-5 seconds and release it.

The LED will begin flashing blue.

Press the WPS button on the “Client” for

3-5 seconds and release it.

The LED will begin flashing blue.

WPS

NOTE – The WPS buttons can be pressed in any order as long as

they are pressed within 2 minutes of each other.

Step 2.

Wait for the pairing process to complete by watching the LEDs on

the devices:

• The LEDs will flash blue for a few seconds after

pressing the WPS button for both AP & Client.

• The LEDs will change to solid blue after

successful pairing and turn off two minutes later.

• The Wireless LEDs will then be solid blue.

• The Client wireless LED could be solid amber

when the association is not able to receive a

high quality HD stream.

If pairing is unsuccessful:

• The LEDs will flash blue for two minutes and

then turn off.

WPS

Wireless

WPS Button