User Manual

Congratulations! You have finished installing your new Wireless Extender
devices. To test your connectivity, turn on the TV and set top box, and then
watch any available TV channel.
Note: To add additional WAP-5836 Clients to your network, you will need to
perform the pairing procedures as explained above.
Troubleshooting
• The LED is not on
• The LED is not on
Make sure that:
• The power cord is connected to the device, and that the power
adapter is properly connected to a functioning power outlet.
• You are using the power adapter that was supplied with the product.
Make sure that:
• The LAN cable connectors are securely plugged in at the WAP-5836
and at the network device (gateway, modem or set top box).
• The connected network device is turned on.
• You are using the correct cable type for your Ethernet equipment,
which is at least UTP CAT5 with RJ45 connectors.
Power
Advanced Settings via the Web-based User Interface
The instructions below are for users who have adequate
networking knowledge. Users are not encouraged to configure
the following settings because this may cause connectivity
issues.
5