User Manual
Table Of Contents
- The cardboard box, the plastic contained in the packaging, and the parts that make up this router can be recycled in accordance with regionally established regulations. Never dispose of this electronic equipment along with your household waste; you m...
- Chapter 1 Introduction
- 1.1 Features
- Chapter 2 Installation
- Chapter 3 Web User Interface
- Chapter 4 Device Information
- Chapter 5 Basic Setup
- Chapter 6 Advanced Setup
- Chapter 7 Diagnostics
- Chapter 8 Management
- Chapter 9 Logout
- Appendix A - Firewall
- Appendix B - Pin Assignments
- Appendix C – Specifications
- Appendix D - SSH Client
- Appendix E - Connection Setup
- Appendix F - WPS OPERATION
- Appendix G - Printer Server
173
USE STATIC IPv4 ADDRESS
Unless your service provider specially requires it, do not select this checkbox . If
selected, enter the static IP address in the IP Address field. Also, don’t forget to
adjust the IP configuration to Static IP Mode as described in section 3.2.
Fixed MTU
Fixed Maximum Transmission Unit. The size (in bytes) of largest protocol data unit
which the layer can pass onwards. This value is 1500 for PPPoA.
ENABLE PPP DEBUG MODE
When this option is selected, the system will put more PPP connection information
into the system log. This is for debugging errors and not for normal usage.
ENABLE IGMP MULTICAST PROXY
Tick the checkbox to enable Internet Group Membership Protocol (IGMP)
multicast. This protocol is used by IPv4 hosts to report their multicast group
memberships to any neighboring multicast routers.
NO MULTICAST VLAN FILTER
Tick the checkbox to Enable/Disable multicast VLAN filter.
Enable WAN interface with base MAC
Enable this option to use the router’s base MAC address as the MAC address for this
WAN interface.
STEP 3: Choose an interface to be the default gateway.
Click Next to continue or click Back to return to the previous step.
STEP 4: Choose an interface to be the default gateway.