User's Manual

11
User Manual for details.
4) PLC Indicator is OFF: This indicator shows that the adapter is paired to the G.hn
Network. If this indicator is off, plug both Powerline Adapters that you’re attempting to pair
into power outlets that are located within the same room. All of the indicators of the device
should blink (approx. 10 seconds), and the PLC Indicator should light up. If the PLC
Indicator does not light up, it may indicate the existing G.hn network is secure and you
have to pair the PG-9172AC to it in “secure mode.” To do so, press the "PLC Sync" Button on
the PG-9172AC for 2 seconds. Within 2 minutes, press the “Config" Button on the PG-9172
for 2 seconds (Holding for more than 4 seconds will clear the security key and require a
re-pairing). The PLC Indicator will then light up GREEN. Afterwards, you can plug the units
back into their original location.
5) PLC Indicator is Blinking RED: This indicator shows that the adapter is paired to the
G.hn Network. If the PLC Indicator is blinking RED, then the adapter is
paired in “non-secure” mode to the G.hn Network. It is optional to pair the device in “secure
mode.” To pair the device in “secure mode," press the "PLC Sync" Button on the PG-9172AC
and the “Config" Button on the PG-9172 for 2 seconds. The PLC Indicator will then light
up GREEN.
* If you have tried all of the above and are still experiencing problems, you can reset all
devices to factory default by pushing the “Reset” Button on the PG-9172AC for more than 10
seconds AND the “Config” Button on the PG-9172 for 10 seconds.
251841536
FOR MORE HELP: For instructions on advanced features, FAQ, etc., please visit the PG-9172AC
online Product Webpage on our website.
PG-9172AC
PG-9172