User's Manual

40
7.4.1 IP config
In the IP configuration tab of one G.hn node, the IPv4 and IPv6 settings can be
read and changed.
IPv4 subsection:
 DHCPv4 enabled: in the case of choosing ”NO" IP configuration in the following
parameters, the IPv4 Address, Subnet Mask, Default Gateway and DNS
should be configured; fill these fields in. In the case of choosing “YES” they will be
filled automatically when configuration is received from the DHCPv4 server.
 IPv4 address/netmask: IPv4 address / netmask of this device.
 Default Gateway: IPv4 gateway to connect the device to other LAN segments.
 DNS: Domain Name Server IP (IPV4).
 Additional address #1/2: additional fixed IPv4 addresses that will always
be configured at boot time.
IPv6 subsection:
 DCHPv6 enabled: in the case of choosing ”NO" IP configuration in the following
parameters, the IPv6 Address, prefix, Default Gateway and DNS should be configured;
fill these fields in. In the case of choosing “YES” they will be filled automatically
when configuration is received from the DHCPv6 server.
 IPv6 Address / prefix: IPv6 address / prefix of the device to read the node's DHCPv6
address in case the DHCPv6 is enabled.
 Default Gateway: IPv6 gateway to connect the node to other LAN segments.
 DNS: Domain Name Server IP (IPV6).
 Additional address #1/2/3/4: additional fixed IPv6 addresses that will always
be configured at boot time.
 IPv6 Link-Local Address: to read the node's Link Local address.
 IPv6 SLAAC address: IPv6 address, automatically obtained by means of the SLAAC
mechanism.
NTPv4/v6 subsection:
 NTPv4/v6 client enabled: Enable/disable NTP client.
 Resynchronization time: Configure re-synchronization interval time in minutes.
 NTP IPv4/v6 address: Hostname or IP (IPv4 or IPv6) of NTP server.