User's Manual

WPS Button

Press the WPS button less than 2 seconds to enable WPS which will allow 2 minutes

for WiFi connection.

DSL

Connect to the DSL port with the DSL RJ11 cable. The VR-3071 supports the

following DSL profiles -

ADSL : ADSL, ADSL 2, ADSL 2+.

VDSL : 8a, 8b, 8c, 8d, 12a, 12b, 17a, 30a and 35b.

USB Port

This port can be used to connect the router to a storage device. It can only be used

for SAMBA(storage) and for a Printer Server. Support for other devices may be

added in future firmware upgrades.

LAN (Ethernet) Ports

You can connect the router to up to four LAN devices using RJ45 cables. The ports

are auto-sensing MDI/X and either straight-through or crossover cable can be used.

ETH WAN PORT

This port is designated to be used for Ethernet WAN functionality only. Use

1000-BASE-T RJ-45 cables to connect to Gigabit WAN server, or 10/100BASE-T

RJ-45 cables for standard network usage. This ports is auto-sensing MDI/X; so

either straight-through or crossover cable can be used.

Power ON

Press the power button to the OFF position (OUT). Connect the power adapter to the

power port. Attach the power adapter to a wall outlet or other AC source. Press the

power button to the ON position (IN). If the Power LED displays as expected then

the device is ready for setup (see section – LED Indicators).

Caution 1: If the device fails to power up, or it malfunctions, first verify that the

power cords are connected securely and then power it on again. If the

problem persists, contact technical support.

Caution 2: Before servicing or disassembling this equipment, disconnect all power

cords and telephone lines from their outlets.