User's Manual

90
Field Description
Traffic Class Name Enter a name for the traffic class.
Rule Order Last is the only option.
Rule Status Disable or enable the rule.
Classification Criteria
Ingress Interface Select an interface: (i.e. LAN, WAN, local, ETH1,
ETH2, ETH3, wl0)
Ether Type Set the Ethernet type (e.g. IP, ARP, IPv6).
Source MAC Address A packet belongs to SET-1, if a binary-AND of its
source MAC address with the Source MAC Mask is
equal to the binary-AND of the Source MAC Mask and
this field.
Source MAC Mask This is the mask used to decide how many bits are
checked in Source MAC Address.
Destination MAC
Address
A packet belongs to SET-1 then the result that the
Destination MAC Address of its header binary-AND to
the Destination MAC Mask must equal to the result
that this field binary-AND to the Destination MAC
Mask.
Destination MAC Mask This is the mask used to decide how many bits are
checked in the Destination MAC Address.
Classification Results
Specify Egress
Interface
Choose the egress interface from the available list.
Specify Egress Queue Choose the egress queue from the list of available for
the specified egress interface.
Mark Differentiated
Service Code Point
The selected Code Point gives the corresponding
priority to packets that satisfy the rule.
Mark 802.1p Priority Select between 0-7.
- Class non-vlan packets egress to a non-vlan
interface will be tagged with VID 0 and the class rule
p-bits.