User's Manual
Table Of Contents
- The cardboard box, the plastic contained in the packaging, and the parts that make up this router can be recycled in accordance with regionally established regulations. Never dispose of this electronic equipment along with your household waste; you m...
- Chapter 1 Introduction
- Chapter 2 Installation
- Chapter 3 Web User Interface
- Chapter 4 Status
- Chapter 5 Config
- Chapter 6 Tools
- Chapter 7 System
- Appendix A - Specifications
- Appendix B - AP / Station
8
2.3 Initial Device Setup
Device Setup
1. Setup the first Wireless Video Bridge by plugging in the power adapter and
press the Power Button to the ON position (IN). Set the Wireless Video
Bridge to AP Mode by sliding the AP/Station Switch to the up position.
2. Connect the Wireless Video Bridge to a Network Device (Gateway, Router,
etc.) with an Ethernet (RJ-45) cable. You can use either Ethernet ports of the
Wireless Video Bridge to make this connection.
3. After you select AP mode thus the Ethernet port (ETH1) will be WAN port,
another Ethernet port (ETH2) is LAN side.